PB 354 - Vacuum Cleaner PROGRESS - Free user manual and instructions

Product type	Cordless stick vacuum cleaner
Model	PB 354
Brand	PROGRESS
Power supply	Rechargeable NiCd battery, 230 V~50 Hz charger
Charging time	Approximately 16 to 18 hours for a full charge
Runtime	Approximately 8 to 9 minutes (depending on model)
Dust container capacity	Not specified
Filter	Washable dust filter with soapy water
Included accessories	Wall mount with charger, foldable crevice nozzle
Main functions	Dry vacuuming on hard floors and carpets, crevice cleaning
Maintenance and cleaning	Empty the container, wash the filter with soapy water, do not machine wash
Safety	Do not vacuum liquids, glowing objects, or flammable dust
Spare parts and repairability	Filters available as spare parts; repairs by authorized dealer
General information	Compliant with EC directives 73/23/EEC and 89/336/EEC

Frequently Asked Questions - PB 354 PROGRESS

How long does it take to fully charge the PB 354 vacuum cleaner?

The first charge takes about 16 to 18 hours. Subsequently, a full charge is also recommended to ensure optimal runtime.

What is the runtime of the vacuum on a full charge?

With a fully charged battery, the runtime is approximately 8 to 9 minutes depending on the model (ZB 250: 8 min, ZB 254: 9 min).

How to clean the dust filter?

Remove the filter from the container, clean it with a standard vacuum cleaner or wash it in warm soapy water. Rinse and dry completely before reinstalling. Do not machine wash.

How to empty the dust container?

Press the release button (3) downwards and pull the container (1) forward. Remove the filter (2) and empty the contents into the trash.

What to do if the runtime becomes less than 8 minutes?

This may be due to charge resistance. Fully discharge the battery by running the vacuum until it stops, then fully recharge it. Repeat if necessary.

Can I use the vacuum to pick up liquids?

No, never vacuum on wet surfaces or liquids. This could damage the appliance.

How to use the crevice nozzle?

Pull out the nozzle (10) and flip it upwards until it clicks. Push it inward to lock it in the use position.

How to install the wall mount?

Drill holes according to the markings, insert wall plugs, screw in the screws leaving 7 mm protruding, then hang the mount. The mount can also be placed flat.

What type of battery is used and how to recycle it?

The vacuum contains a NiCd battery. At the end of its life, fully discharge it, remove it, and take it to a collection center or repair shop. Do not dispose of it in household waste.

Where can I find replacement filters?

Filters are available as spare parts from specialized dealers or the PROGRESS after-sales service.

USER MANUAL PB 354 PROGRESS

Please read these operating instructions carefully. Above all please observe the safety information on the first pages of these operating instructions! Please keep these operating instructions for later reference. Pass them on to any subsequent owner of the appliance.

Description of the Appliance

1 Dust container
2 Dust filter
3 Release button
4 On/off switch
5 Charge control display
6 Charge socket
7 Wall mounting and charger
8 Mains plug
9 Jack plug
10 Fold-down crevice nozzle

! Safety instructions

• Do not vacuum wet surfaces.
• Do not use the vacuum cleaner on surfaces that have been treated with flammable solvents until they are completely dry.
• Do not use your vacuum cleaner to vacuum hot items such as a glowing cigarette end.
• Never use the vacuum cleaner to pick up combustible dust.
• Under no circumstances should you oil or grease the motor.
• Do not expose the vacuum cleaner to direct sunlight or any source of heat.
• For maintenance and repair please contact your local dealer or authorised service personnel. Never attempt to carry out repairs to the vacuum cleaner yourself.
• Only use the appropriate original charging devices for this model.

This appliance complies with the following EC directives:

• 73/23/EWG dated 19.02.1973 "Low Voltage Directive", including Directive Amendment 93/68/EWG
• 89/336/EWG dated 03.05.1989 "EMC Directive", including Amendment Directive 92/31/EWG

Before using for the first time

Before using your vacuum cleaner for the first time you should charge the battery for approx. 16-18 hours.

With a fully charged battery you can vacuum for approx. 8 minutes with model ZB 250 and for approx.

9 minutes with model ZB 254.

Attaching the wall mounting (Fig. A)

Select a position near a room socket to attach the wall mounting.

Hold the mounting against the wall and mark the points for the fastening screws.
Use a drill to drill the holes for the screws and push in the plastic plugs provided.
Position the wall mounting and then insert the screws so that they project by at least 7mm
Then lower the wall mounting and tighten the screws.
The appliance can equally well be stored standing on a table, the floor or any other horizontal surface.

Charging (Fig. B)

The charger (7) may only be connected to a power source of 230V , 50Hz .

Insert the vacuum cleaner into the wall mounting (7) and check that the jack plug (9) on the wall mounting fits correctly into the charge socket (6) on the vacuum cleaner.

GB

The charge control display (5) will come on and charging will begin. It will also come on if the battery is already fully charged. Always leave your vacuum cleaner in the wall mounting when not in use in order to guarantee optimal suction power.

To return to full suction capacity once a battery has been completely discharged requires a charging period of 18 hours.

If a fully charged battery works for less than 8 minutes it might be the result of a build up of resistance to charging which occurs if the vacuum cleaner is always used only for short periods. If this happens you should charge the battery fully and use the vacuum cleaner until the battery is empty.

After this recharge the battery. Repeat this procedure if necessary.

Information: The battery should not be charged in room temperatures below 0^ or above 40^ .

The charger can heat up during charging.

Using the vacuum cleaner (Fig. C)

Remove your vacuum cleaner from the wall mounting by pushing it straight upwards.

To switch on the appliance push the on/off switch (4) forwards.

To switch the appliance off, push the on/off switch backwards.

Recharge your vacuum cleaner after use.

Using the crevice nozzle

Pull out the crevice nozzle (10) and fold upwards (E).
To lock in place push the crevice nozzle in.

Maintenance and care (Fig. D)

Cleaning the dust filter and dust container

Ensure that the vacuum cleaner is switched off.

Press the release button (3) downwards and slowly pull the dust container (1) forwards.
Remove the dust filter (2).
Empty the dust container into the rubbish bin.
To clean the dust filter (2) you can use your normal household vacuum cleaner. If necessary wash the dust filter in lukewarm soapy water and rinse it out thoroughly.

Important: Do not wash synthetic parts of the vacuum cleaner in a machine.

Ensure that the filter is fully dry before you insert it again. After cleaning do not forget to put the dust filter back into the vacuum cleaner before using it again.

Damaged or excessively dirty dust filters should be replaced. Filters can be obtained as spare parts.

Disposal (Figs. F and G)

Your vacuum cleaner contains a re-chargable NiCd battery.

The vacuum cleaner can be re-charged many times and has a long life-span if the suction power is repeatedly topped up.

Should it nonetheless be necessary one day to replace your battery-powered vacuum, please dispose of it with due consideration for the environment.

Switch the vacuum cleaner on and let it run until the battery has run down completely.
Open the battery vacuum casing.

GB

Ensure that the battery has not short-circuited. Remove the batteries and pull the connection leads off the battery connections.
Do not put the removed battery into the dustbin but hand it in at a repair workshop or at a public battery collecting point.

Customer Service

Our products are of the highest quality. Should you nevertheless have questions concerning the use of this appliance, please write to us. Only with your support can we be sure to develop appliances to suit your needs.